Advertisement
Step 8 DLP panel setting
The wireless curtain motor can work with DLP panel, there are two ways for control:
Setting 1:
The button setting is shown as follows.(HDL-BUS Pro Tool Setup)
Operation: (Parameter 1 is "1(switch no.)", parameter 2 is "on", "off", "stop" or "percentage"
Long press the button, open or close the curtain, if loosen the button, it will stop running . If fully open or close, it will stop running auto-
matically.
Short press the button, it will be based on the percent to control the curtain
Setting 2:
The button setting is shown as follows.(HDL-BUS Pro Tool Setup)
Operation: short press the button, control the curtain open, close or stop.
Step 9 Easy Programming
Keep pressing the button for 10S,the LED will flash 2 times/2s. The device will enter into easy programming mode.
Now, the panel will display "programming" , then keep pressing the shift buttons (button 9 and 10) of DLP switch
at the same time, the panel will display "external programming".
In this mode, you can control the motor by PROG button. Keep pressing any panel button, it will cover the original
target. Short press the button, it will add the motor control
Long press the button of motor for 10s, it can exit this status. If it is no action, it will exit automatically after 20min
without operation.
Packing List
HDL-MWM70-RF.12
■
Datasheet
■
Professional Home and Building Automation
www.hdlautomation.com
*1
*1
.
Do you need help? Contact with us
support@hdlchina.com.cn
Wireless curtain motor
HDL-NWN70-RF.12
7/ 7
Advertisement
