Juniper ACX500 Hardware Manual page 125

1. Mount the antenna to any fixed surface by using the GNSS antenna mast or stanchion clamp in an
area with clear and open view of the sky.
2. Route the coaxial cable from the newly installed antenna into the building following the
manufacturer's antenna safety guidelines.
3. Route the coaxial cable from the building's head-end to the server's installation site, and connect it to
the router's GNSS port (RF input). See
View of the ACX500 Outdoor Router
4. Verify that the router is receiving good signal through the GNSS antenna by observing the GPA 1PPS
LED on the ACX500 router.
WARNING:
• Have a qualified technician and or certified electrician perform the installation.
• Observe all local and regulatory standards and ordinances.
• Grounding the unit (metal mast or ground cable to the unit's base) is required for the
lightning protection to work properly.
WARNING: Do not install the GNSS antenna near overhead power lines or other
electric light or power circuits, or where it can come into contact with such circuits.
When you install the antenna, take extreme care not to come into contact with such
circuits, because they might cause serious injury or death. For proper installation and
grounding of the antenna, refer to local, national, and international electrical codes (for
example, U.S.: NFPA 70, National Electrical Code, Article 810; Canada: Canadian
Electrical Code, Section 54; and so on).
Warnung Installieren Sie die GNSS-Antenne nicht in der Nähe von Überlandleitungen
oder anderen elektrischen Licht- oder Stromkreisen, wo sie mit solchen Schaltungen in
Kontakt kommen können. Gehen Sie bei der Installation der Antenne mit äußerster
Vorsicht vor, damit Sie mit diesen Schaltkreisen nicht in Kontakt kommen, da dies zu
schweren Verletzungen oder zum Tod führen könnte. Informationen zur
ordnungsgemäßen Installation und Erdung der Antenne entnehmen Sie den örtlichen,
nationalen und internationalen elektrischen Richtlinien (zum Beispiel US: NFPA 70,
National Electrical Code, Article 810; Kanada: Canadian Electrical Code, Abschnitt 54
usw.)
ACX500 GNSS Antenna Power Specification
Table 33 on page 117 lists the electrical power specification for the ACX500 GNSS antenna.
"Front Panel of an ACX500 Indoor Router" on page 53
for the GNSS antenna port location on the ACX500 routers.
116
and Top