Advertisement
Setup Screens:
These screens are used for properly configuring system based on the structure type that
is being installed. By using the "UP" and "DWN" buttons the user or maintenance
personnel can view and edit the configuration as applicable by pressing the "ENTR"
button after the selecting the desired choice the next screen will be entered.
Configuration Type Screen:
A) To change configuration of controller go to 'Config Type' screen' and press
"ENTR". This will enable you to select either an "E" "A" or "D" tower type. Sub
categories such as E1, E2 etc. will be addressed later in the configuration
menu.
B) Use the "UP" and "DWN" buttons to scroll and select tower style A, D, or E.
Then press "ENTR".
NOTE: If 'Tower Style D' is selected, the system will automatically proceed to
step F, skipping steps D and E since side markers (L810) are not used in D style
configurations. Any information previously in the system as indicated in omitted
steps will be changed to "0" if switched back to an E or A style configuration and
will have to be re-entered to match what is installed on the tower.
NOTE: System will reset when tower style is changed.
C) Select for the presence of an External GPS using the "UP" and "DWN" buttons,
"YES" indicates an external GPS is being used, "NO" is the standard
configuration without an external GPS. Press "ENTR" after selection.
CONFIG TYPE X
'Enter to change'
Tower style = E
'enter' to change
Ext GPS = NO
u/d=chg, enter=done
1501 Route 34 South, Farmingdale, NJ 07727 Tel: (732)
919-3119 Fax: (732) 751-5778 www.dialight.com
Document No: 9100-127-1958-99 Rev F
Advertisement
