Advertisement
After about 2 minutes the system will reset on its own to save the configured
information.
The Reset button located in the middle bottom of the board can also be pressed to reset
the system.
Resetting is required so the controller saves the configured information to throw alarms
on changes occurring during the operation of the system.
Main Menu Screens:
The next screens are paged through using the "UP" and "DWN" buttons. The user or
maintenance personnel can view and edit the configurations as applicable by pressing
the "ENTR" button to enter into each main menu screen.
Pressing the "CLR" in the selected screens takes the user back to the main screens.
Upon resetting or powering and powering up the system this is the first screen that is
displayed.
•
Status Screen – Config type:
•
Screen: Tower style:
This screen displays what the Base Controller has been configured for, if the amount of
beacons configured does not match what is actually connected then alarms will be
generated as "config" alarms. Only powered fixtures and fixtures connected to the
RS485 will be detected. The "B y" in second line will indicate the firmware level of main
controller.
NOTE: If the installer selects 3 beacons and only 1 is powered AL1 (config ERR) will be
lit and recorded in the alarm log.
CONFIG TYPE X
'Enter to change'
CONFIG TYPE X
'Enter to change'
Tower Style: X X
86X ,X 810 B y
1501 Route 34 South, Farmingdale, NJ 07727 Tel: (732)
919-3119 Fax: (732) 751-5778 www.dialight.com
Document No: 9100-127-1958-99 Rev F
Advertisement
