Garmin G1000 NXi Pilot's Manual page 501

Message
XPDR1 ADS-B 1090 – Datalinik:
ADS-B 1090 receiver has failed.
XPDR1 ADS-B FAIL – Transponder:
XPDR1 is unable to transmit ADS-B
messages.
XPDR1 ADS-B NO POS-Transponder:
ADS-B is not transmitting position.
XPDR1 ADS-B TRFC – Transponder:
ADS-B traffic has failed
XPDR1 ADS-B UAT – Datalink:
ADS-B in UAT receiver has failed.
XPDR1 CONFIG – XPDR1 config
error. Config service req'd.
XPDR1 CSA FAIL - Traffic: ADS-B In
traffic alerting has failed.
XPDR1 FAIL – XPDR1 is inoperative. There is no communication with the #1 or #2 transponder.
XPDR1 FAULT – Datalink: ADSB-B in
has failed.
XPDR1 FIS-B WX – Datalink: FIS-B
Weather has failed.
XPDR1 OVER TEMP - Transponder:
Transponder over temp.
XPDR1 PRES ALT –Transponder:
ADS-B no pressure altitude.
XPDR1 SRVC – XPDR1 needs service.
Return unit for repair.
XPDR1 UNDER TEMP -
Transponder: Transponder under temp.
XTALK ERROR – A flight display
crosstalk error has occurred.
190-02177-02 Rev. A
Comments
A failure has been detected in the 1090 receiver.
ADS-B is inoperative. The transponder may not be receiving a valid GPS position.
Other transponder functions may be available. Service when possible.
The transponder is not able to receive position information.
The Transponder is incapable of processing traffic information.
A failure has been detected in the UAT receiver.
The transponder configuration settings do not match those of backup configuration
memory. The system should be serviced.
ADS-B Conflict Situational Awareness (CSA) is unavailable.
The transponder is unable to receive ADS-B information.
The transponder is unable to receive FIS-B weather information.
The system has detected an over temperature condition in XPDR1. The transmitter
operates at reduced power. If the problem persists, the system should be serviced.
Unable to provide pressure altitude information.
The #1 transponder should be serviced when possible.
The system has detected an under temperature condition in XPDR1. The transmitter
operates at reduced power. If the problem persists, the system should be serviced.
The MFD and PFD are not communicating with each other. The system should be
serviced.
Garmin G1000 NXi Pilot's Guide for the Cessna NAV III
APPENDIX A
481