Echo DCS-2500T Operator's Manual page 29

1. Leave supporting limbs till last
2. Slide support logs under trunk
Cutting instruction
Limbing
 Don't saw above chest height.
Limbing a fallen tree is much the same as bucking.
Never remove a limb from a tree while it is supporting your
weight.
Be careful of the tip touching other limbs.
Always use both hands.
Don't cut with the saw overhead or the bar in a vertical posi-
tion.
If the saw should kickback, you may not have good enough
control to prevent possible injury.
Know how limb is stressed
If you have thick branches, work from the outside to the inside
to avoid your bar and chain get stuck.
Even when limbing, use of the spiked bumper makes it easy to
control the chain saw and lessens kickback.
Bucking
 Stay on the uphill side of logs.
Bucking is the sawing of a log or fallen tree into smaller pieces.
There are a few basic rules which apply to all bucking opera-
tions.
Keep both hands on the handles at all times.
Support logs if possible.
When cutting on a slope or hillside, always stand uphill.
No standing on log.
27
CAUTION
CAUTION