Table of Contents
Advertisement
1. Record the information about the unit. (Section 3.1)
2. Set COM settings for the device that will be connected to ProtoAir. (Section 3.3)
3. Connect the ProtoAir 3 pin RS-485 R1 port to the RS-485 network connected to each of the devices.
(Section 4.1)
4. Connect the ProtoAir 3 pin RS-485 R2 port to the field protocol cabling. (Section 4.2)
5. Connect power to ProtoAir's 3 pin connector. (Section 4.5)
6. Connect a PC to the ProtoAir via Ethernet cable or by the ProtoAir's Wi-Fi Access Point. (Section 5)
7. Use a web browser to access the ProtoAir Web Configurator page to select the profile of the device
attached to the ProtoAir and enter any necessary device information. Once the device is selected, the
ProtoAir automatically builds and loads the appropriate configuration. (Section 6)
Quick Start Guide
Page 3 of 66
Siemens ProtoAir Start-up Guide
Advertisement
Table of Contents
