Advertisement
Quick Links
Premium Microphone Boom Arm Desk Mount
Instruction Manual
SKU: STAND-MIC02
Scan the QR code with your mobile device or follow the link
for helpful videos and specifications related to this product.
https://vivo-us.com/products/stand-mic02
GET IN TOUCH | Monday-Friday from 7:00am-7:00pm CST
help@vivo-us.com
www.vivo-us.com
Chat live with an agent!
309-278-5303
Advertisement
Related Manuals for Vivo STAND-MIC02
Summary of Contents for Vivo STAND-MIC02
- Page 1 Premium Microphone Boom Arm Desk Mount Instruction Manual SKU: STAND-MIC02 Scan the QR code with your mobile device or follow the link for helpful videos and specifications related to this product. https://vivo-us.com/products/stand-mic02 GET IN TOUCH | Monday-Friday from 7:00am-7:00pm CST help@vivo-us.com...
-
Page 2: Package Contents
WARNING! If you do not understand these directions, or if you have any doubts about the safety of the installation, please call a qualified technician. Check carefully to make sure there are no missing or defective parts. Improper installation may cause damage or serious injury. Do not use this product for any purpose that is not explicitly specified in this manual. -
Page 3: Assembly Steps
ASSEMBLY STEPS STEP 1 Clamp Installation Grommet Installation Loosen the knob on Clamp (B). Loosen the knob on Clamp (B). Disassemble Clamp (B) by removing Clamp Screws (B1), separating Pole Base (B2) from Clamp (B) using 3mm Allen Wrench (T-A). Remove adhesive backing from Soft Pad (F) on place on the under- Use a Phillips screwdriver to separate Hand Bolt... - Page 4 STEP 1 - Continued Grommet Installation - Continued If your desktop does not have an existing grommet hole, pre-drill a hole using a drill and a 3/8” (10mm) drill bit. Insert Hand Bolt (B3) with Plate (B4) through grommet hole and secure to Pole Base (B1) by tightening Hand Bolt.
- Page 5 STEP 3 Loosen set screw on Clamp (B) using 3mm Allen Wrench (T-A) and insert Arm (A). Tighten set screw on Clamp (B) to secure and increase the rotation resistance. STEP 4 Separate Ball Joint (C) by loosening Knob (C1). Remove Screw (C2) and Ball (C3) from Outer Casing (C4).
- Page 6 STEP 5 Secure microphone to Ball Joint (C). Slide cable management tabs off Arm (A) to neatly route cable. Reattach by sliding back into place. NOTE: Please do note attempt to pry tabs off; tabs may snap or break if too much force is applied.
- Page 7 STEP 6 To adjust microphone position, loosen Knob (C1) on Ball Joint (C) and adjust positioning. Retighten Knob (C1) to secure. STEP 6 Adjust tension of Arm (A) using 3mm Allen Wrench (T-A). Place Plastic Cover (D) over joint in Arm (A).
- Page 8 AVG. RESPONSE TIME (within office hrs) - 23% within < 15m - 38% within < 30m - 61% within < 1hr - 83% within < 2hr - 92% within < 3hr FOR MORE VIVO PRODUCTS, CHECK OUT OUR WEBSITE AT: www.vivo-us.com...
Need help?
Do you have a question about the STAND-MIC02 and is the answer not in the manual?
Questions and answers