Table of Contents
Advertisement
S
S
UPER
ERVER 1027R-WTRFTP User's Manual
Hard Drive Backplane
The hard drives plug into a backplane that provides power and drive ID. A RAID
controller can be used with the backplane to provide data security. The operating
system you use must have RAID support to enable the hot-swap capability of the
drives. The backplane is already preconfigured, so there are no jumpers or switches
present on it.
DVD-ROM Drive Installation
As an option, a slim DVD-ROM may be installed in the 1027R-WTRFTP.
Installing or Replacing a DVD-ROM Drive
1. Power down the system and if necessary, remove the server from the rack.
2. Remove the chassis cover.
3. Unplug the drive's power and data cables from the serverboard and/or back-
plane.
4. Unlock the mini-bezel lock scew and remove the mini-bezel (grate) from the
drive bay The bezel can be removed by pulling out the hard drive beneath the
DVD-ROM, then pulling the mini-bezel forward.
5. When installing or removing a DVD-ROM drive, the mini bezel lock screw
must be removed and the drive tray must be completely seperated from the
chassis.
6.
Remove the DVD-ROM from the drive tray by removing the drive screws,
then secure the replacement DVD-ROM into the drive tray, using the drive
screws.
7. Reattach the drive tray to the chassis by replacing the mini-bezel lock screw,
and tightening it from inside the chassis.
6-8
Advertisement
Table of Contents
