evoheat Evo Fusion-i Quick Start Manual

Hide thumbs Also See for Evo Fusion-i:

IMPORTANT THINGS TO NOTE

•

Ensure you meet the minimum clearances and recommended installation locations as outlined in the manual.

•

All heat pump accessories are contained in a plastic bag inside the packaging of your heat pump unit.

1. Position the heater on a level pad in the desired location on the pool water return line (as shown in the

example image below).

2. Install the supplied antivibration rubber pads under the feet of the unit.

3. Install the supplied condensation barb to the underside of the unit and direct the condensation to an

appropriate drainage point.

ool uction

NOTE: Evo heat pumps standard plumbing fitting size can accept 40mm NB PVC pipe for connection to the pool or spa filtration

plumbing.

1. Attach the supplied barrel unions to the cold inlet and hot outlet (hand tighten).

2. Use plumbing tape and ensure the 'O' ring is in position when sealing.

3. Install a 3-way valve at the cold-water inlet and create a bypass by connecting a "T" piece to the heated line.

4. Make the plumbing connections and brace pipework where necessary.

ilter

ater pump

ool eturn

Table of Contents

Do you have a question about the Evo Fusion-i and is the answer not in the manual?

Page 1 IMPORTANT THINGS TO NOTE • Ensure you meet the minimum clearances and recommended installation locations as outlined in the manual. • All heat pump accessories are contained in a plastic bag inside the packaging of your heat pump unit. PRE-INSTALLATION 1.
Page 2 (provided your pool pump is running) when the pool temperature falls more than 1°C below the desired set temperature. IF YOU WISH TO SET TIMERS, ESTABLISH WI-FI CONNECTION (UPGRADE OPTION) OR FOR ADDITIONAL INFORMATION - PLEASE REFER TO THE OWNER’S MANUAL OR THE EVOHEAT YOUTUBE CHANNEL. DIGITAL COPIES OF ALL EVOHEAT MANUALS CAN BE FOUND ONLINE: WWW.EVOHEAT.COM.AU/MANUALS...