PowerBox Systems MERCURY SR2 Instruction Manual page 6

• Jeti EX-BUS
One output of the receivers you intend to use must be set to EX-BUS. The frame
rate should be set to 10ms, and the Failsafe function must be OFF. If you intend
to use only one receiver, then it must be connected to RX1 to transmit telemetry
data. If a GPS III or a PBS-TAV is connected to the FastTrack input, the Mercury
also delivers this flight data to the transmitter.
• Futaba S.BUS2
Connect one or two receivers to RX1 and RX2 at the S.BUS2 output. If only one
receiver is to be used, it must be connected to RX1 to provide telemetry transmis-
sion. This receiver must also be defined as the telemetry receiver at the transmit-
ter. In order to receive telemetry data, you must carry out a Load New process in
the Telemetry Sensor menu; this action completely erases the sensor list. Now
select Slot 16 in the sensor list, and select PowerBox. The telemetry data now
appear in Slot 16 or later. If a GPS III or a PBS-TAV is connected to the FastTrack
input, the Mercury also delivers this flight data to the transmitter.
Note: do not attempt to register the PowerBox as a sensor at the transmitter; this
function is not implemented.
Note: do not attempt to register the PowerBox as a sensor at the transmitter;
this function is not implemented.
• Spektrum SRXL 2
Connect one or two SPM4651T satellites to the PowerBox Mercury SR2 using
the optional adapter lead set (#9192). If only one receiver is to be used, it must
be connected to RX1 to provide telemetry transmission. At the transmitter you
will now see the battery data displayed under PowerBox Sensor. If a GPS III or a
PBS-TAV is connected to the FastTrack input, the Mercury also delivers this flight
data to the transmitter.
By default, the Mercury works in DX18 compatibility mode.
• Multiplex M-Link
Set the B/D sockets of the receivers you intend to use to SRXL V2. This gives you
sixteen channels. The Failsafe function must be OFF.
To use telemetry, you must disable the Telemetry function of one receiver using
Multiplex Launcher. The Tele output of the PowerBox should be connected to the
Sensor input of the other receiver.
If a GPSIII or a PBS-TAV is connected to the FastTrack input, the Mercury also
delivers this flight data to the transmitter.
6 PowerBox-Systems − World Leaders in RC Power Supply Systems