PowerBox Systems MERCURY SR2 Instruction Manual page 4

1.INITIAL INSTALLATION: GENERAL SEQUENCE OF OPERATIONS
When installing the unit, it is important to keep to the standard sequence described
below, and adhere to the subsequent setup stages, as this ensures that your instal-
lation of the PowerBox Mercury SR2 will be swift and problem-free. The individual
points are explained in full in the remainder of these instructions:
- Mounting the PowerBox, switch and screen
- Connecting the receiver and batteries
- Settings in the Basics menu
- Setting up all the functions at the transmitter
- Carrying out the Setup Assistant
- Carrying out the Door Sequencer Assistant
- Assigning all remaining functions in Output Mapping
- Setting up all control surface travels, flight modes, Dual-Rate, Expo etc. at the
transmitter
- Using Servo Matching to equalize servos operating in parallel
- Learning the stick end-points in the iGyro menu
- iGyro set-up flight
- Fine-tuning the iGyro
entfällt ohne Fahrwerkstüren
4
entfällt ohne Gyro
5
2.INSTALLATION, CONNECTIONS
a) Mounting
The PowerBox Mercury SR2 should be mounted in the model on a robust sub-struc-
ture using the four screws, rubber grommets and brass eyelets supplied in the set.
The installed location is not important, but if an iGyro SAT is to be used, the sensor
must be installed perpendicular to the model's centreline. Ideally the TFT screen
should be in a clearly visible location. The bright screen lighting makes it easy to
read even in sunshine, so no special provisions have to be made here. The screen is
connected to the socket marked Display on the side of the PowerBox.
The switch should be mounted in the fuselage side. As with previous units, a woo-
den doubler should be glued to the inside of the switch aperture - especially if the
fuselage is made of GRP - in order to avoid subjecting the switch to powerful vi-
bration. The set includes a template for the switch aperture. An exposed switch is
4
5
5
PowerBox-Systems − World Leaders in RC Power Supply Systems
4
5