Removing And Installing The Support Bracket - IBM IntelliStation M Pro Hardware Maintenance Manual

4. Pull the cover-release latch away from the computer, and push the cover toward
For instructions for replacing the side cover, see "Replacing the side cover" on page
67.
Attention:
computer. Operating the computer with the cover removed might damage computer
components.

Removing and installing the support bracket

When working with some devices, such as hard disk drives, adapters, and memory
modules, you must first remove the support bracket to access the device.
Complete the following steps to remove the support bracket:
1. Review the "Installation guidelines" on page 31. and the guidelines in "Handling
2. Remove the side cover ("Removing the side cover" on page 52).
3. Pull out on the rear end of the support bracket approximately 150 mm (6 in.).
the rear of the computer. Lift the side cover off the computer, and set it aside.
For proper cooling and airflow, replace the cover before turning on the
static-sensitive devices" on page 31.
94
13
Installing options
53