Machine Configuration Menu; Selecting, Changing And Saving Parameters; Calibration; Exit Menu - EWM M1.83-A-1 Operating Instructions Manual

5.5

Machine configuration menu

5.5.1

Selecting, changing and saving parameters

0
l
Display
099-M183xA-EW501
15.7.2022
Setting/selection

Calibration

The machine will be calibrated for approx 2 seconds each time it is switched on.
Exit the menu
Exit

Machine configuration

Settings for machine functions and parameter display
Dynamic power adjustment > see 7.4 chapter
Time-based power-saving mode > see 5.6 chapter
Time to activation of the power-saving mode in case of inactivity.
Setting = disabled or numerical value 5-60 min..
Arc detection for welding helmets (TIG)
Modulated waviness for better arc detection
-------Function enabled
-------Function disabled
Service menu
Any changes to the service menu should be agreed with the authorised service person-
nel.
Software version of the machine control
Version display
Functional characteristics
B
B
A
Figure 5-27
Machine configuration menu
35