Conventional Mig/Mag Welding (Gmaw Non Synergic); Mma Welding; Welding Task Selection; Arcforce - EWM M1.83-A-1 Operating Instructions Manual

Functional characteristics

MMA welding

Display
5.2.8

Conventional MIG/MAG Welding (GMAW non synergic)

You can only change the JOB number when no welding current is flowing.
5.3 MMA welding
5.3.1

Welding task selection

• Select MMA JOB 128 > see 8.1 chapter.
You can only change the JOB number when no welding current is flowing.
5.3.2

Arcforce

During the welding process, arcforce prevents the electrode sticking in the weld pool with increases in
current. This makes it easier to weld large-drop melting electrode types at low current strengths with a
short arc in particular.
Display
28
Setting/selection
Slope time of main program P
End current (as a percentage, dependent on main current)
End current time (duration of end current)
Burn-back correction
Setting/selection
Arcforce correction
• Increase value > harder arc
• Decrease value > softer arc
to end program P
A END
Figure 5-15
Figure 5-16
Figure 5-17
3s
3s
099-M183xA-EW501
15.7.2022