EWM M1.83-A-1 Operating Instructions Manual page 24

Functional characteristics
MIG/MAG welding
Latched special
The activation or setting of this operating mode is described in the chapter Program se-
quence > see 5.2.6 chapter.
1st cycle
• Press and hold torch trigger.
• Shielding gas is flowing (gas pre-flow).
• Wire feed motor runs at "wire creep speed".
• Arc ignites when the wire electrode makes contact with the workpiece,
welding current is flowing (start program P
2nd cycle
• Release torch trigger.
• Slope to main program P
3rd cycle
• Press and hold torch trigger.
• Slope to end program P
4th cycle
• Release torch trigger.
• Wire feed motor stops.
• The arc is extinguished once the wire burn-back time has elapsed.
• Gas post-flow time elapses.
24
Figure 5-10
).
START
.
A
.
END
099-M183xA-EW501
15.7.2022