Intended Use; Use And Operation Solely With The Following Machines; Software Version; Documents Which Also Apply - EWM M1.83-A-1 Operating Instructions Manual

Intended use

Use and operation solely with the following machines

3 Intended use
Hazards due to improper usage!
The machine has been constructed to the state of the art and any regulations and stand-
ards applicable for use in industry and trade. It may only be used for the welding proce-
dures indicated at the rating plate. Hazards may arise for persons, animals and material
objects if the equipment is not used correctly. No liability is accepted for any damages
arising from improper usage!
• The equipment must only be used in line with its designated purpose and by trained or ex-
pert personnel!
• Do not improperly modify or convert the equipment!
3.1 Use and operation solely with the following machines
This description may only be applied to machines with the machine control M1.83-A-1
(Picomig puls TKG).
3.2

Software version

The software version of the machine control can be displayed in the machine configuration menu
(menu Srv) > see 5.5 chapter.
3.3

Documents which also apply

3.3.1

Warranty

For more information refer to the "Warranty registration" brochure supplied and our information regarding
warranty, maintenance and testing at www.ewm-group.com!
3.3.2

Declaration of Conformity

This product corresponds in its design and construction to the EU directives listed in the decla-
ration. The product comes with a relevant declaration of conformity in the original.
The manufacturer recommends carrying out the safety inspection according to national and in-
ternational standards and guidelines every 12 months.
3.3.3

Welding in environments with increased electrical hazards

Power sources with this marking can be used for welding in an environment with increased elec-
trical hazard (e.g. boilers). For this purpose, appropriate national or international regulations
must be followed. The power source must not be placed in the danger zone!
3.3.4

Service documents (spare parts and circuit diagrams)

No improper repairs and modifications!
To prevent injuries and damage to the machine, only competent personnel (authorised
service personnel) are allowed to repair or modify the machine.
Unauthorised manipulations will invalidate the warranty!
• Instruct competent personnel (authorised service personnel) to repair the machine.
Original copies of the circuit diagrams are enclosed with the unit.
Spare parts can be obtained from the relevant authorised dealer.
3.3.5

Calibration/Validation

An original certificate is enclosed with the product. The manufacturer recommends calibration / validation
at intervals of 12 months.
12
WARNING
WARNING
099-M183xA-EW501
15.7.2022