Advertisement
ControlLogix Power Supply
Tools Required
When installing the standard or ControlLogix-XT versions of your 1756 chassis and power supplies, the following items are required:
• 3.18 mm (0.125 in.) slotted screwdriver
• 6.35 mm (0.25 in.) slotted or #2 Phillips screwdriver
• Torque screwdriver
• Needle-nose pliers
ATTENTION: If this equipment is used in a manner not specified by the manufacturer, the protection provided by the equipment may be impaired.
ATTENTION: Make sure the chassis is mounted and all panel fabrication is complete before you remove the protective label. This label protects the power supply
from metal shavings falling inside the power supply and damaging it during operation.
Install the Power Supply
1. Make sure that the chassis is installed and grounded correctly.
2. Align the power-supply circuit board with the card guides on the left side of the chassis.
3. Slide the power supply back until it is flush with the front of the chassis.
Card Guide
4. Tighten the top and bottom screws to fasten the power supply to the chassis.
6
• Crimper
• Wire stripper
• Drill
Rockwell Automation Publication 1756-IN619E-EN-P - September 2019
Hide quick links:
Advertisement
