Step 4: Option A - Attach The Mounting Plate To The Wall - Insignia NS-OTRC15SS9 Installation Manual

Step 4: Option A - Attach the mounting plate to the wall

Note: Depending on
your stud locations,
your installation may
look different. You
should insert toggle
bolts into drywall and
wood screws into
studs.
1 Remove the rear wall template.
2 Remove the mounting plate from the back of your microwave using a #1 Phillips screwdriver. Replace the two screws
back into the microwave after removing the mounting plate.
3 Insert the toggle bolt(s) through the front of the mounting plate into the hole(s) that are not going into a stud, and
then attach the toggle wings ¾" (1.9 cm) onto each bolt. Hold your mounting plate up to the holes in your wall to
identify the correct position.
Note: The top of the mounting plate is indicated with an arrow. The mounting plate's hooks are on the front.
4 Place the mounting plate against the wall and insert the toggle wings into the holes you drilled in the drywall. Pull the
mounting plate away from the wall to help tighten the toggle wings.
Mounting plate
Bolt
www.insigniaproducts.com
Wing
NS-OTRC15SS9
13