Table of Contents
Advertisement
8 Manufacturer's information
8 Manufacturer's information
8.1 Delivery
● Check that all parts are present and check for any damage
immediately upon receipt.
The product's performance is tested at the factory. The scope
of delivery is apparent from the dispatch documents and the
design from the order number.
8.2 Transport
1. Only transport the product by suitable means. Do not drop.
Handle carefully.
2. After the installation dispose of transport packaging ma-
terial according to relevant local or national disposal regu-
lations / environmental protection laws.
8.3 Storage
1. Store the product free from dust and moisture in its ori-
ginal packaging.
2. Avoid UV rays and direct sunlight.
3. Do not exceed the maximum storage temperature (see
chapter "Technical data").
4. Do not store solvents, chemicals, acids, fuels or similar
fluids in the same room as GEMÜ products and their spare
parts.
8.4 Scope of delivery
The following is included in the scope of delivery:
- Solenoid valve with solenoid coil
- Plug
- Installation, operating and maintenance instructions
GEMÜ 202
9 Installation in piping
The equipment is subject to pressure!
▶ Risk of severe injury or death.
Depressurize the plant.
●
Completely drain the plant.
●
Hot plant components!
▶ Risk of burns.
●
Operating pressure too high or working medium temperat-
ure too high
▶ Damage to the valve body
Only install the solenoid valve in aligned pipes in order to
●
avoid stresses in the valve body.
Do not exceed the permissible operating pressure.
●
Do not exceed the permissible temperature of the work-
●
ing medium.
9.1 Installation with solvent cement sockets
Wrong solvent cement
▶ Valve body will be damaged.
Only use solvent cement suitable for the valve body.
●
▶ The solvent cement is not included in the scope of deliv-
ery.
Only use suitable solvent cement!
●
1. Apply solvent cement inside the valve body socket con-
nections and on the piping as specified by the solvent ce-
ment manufacturer.
2. Solvent cement the valve body to the piping.
9.2 Installation with threaded sockets
Thread sealant
▶ The thread sealant is not included in the scope of deliv-
ery.
Only use appropriate thread sealant.
●
● Screw the threaded connections into the piping in accord-
ance with valid standards.
12 / 20
WARNING
CAUTION
Only work on plant that has cooled
down.
CAUTION
CAUTION
NOTICE
NOTICE
www.gemu-group.com
Advertisement
Table of Contents
