Help Guide
Data Projector
VPL-CWZ10/CXZ10
Correcting a Horizontal Trapezoid
If the screen is trapezoidal, perform a keystone correction.
Press the KEYSTONE key on the Remote Commander twice.
1
The adjustment menu will be displayed.
You can also display the adjustment menu from [H Keystone] in the
Adjust the value with the
2
A: Increasing the value in the negative direction makes the left side of the screen smaller.
B: Increasing the value in the positive direction makes the right side of the screen smaller.
Press the RESET key to return to the non-corrected state.
Note
Because keystone correction is an electronic form of correction, the image quality may be reduced.
If vertical correction (V keystone correction) and horizontal adjustment (H keystone correction) are performed at the same time,
the values in each adjustment menu may not reach the maximum.
If you press the KEYSTONE key on the Remote Commander and switched between keystone correction and corner keystone
correction, the adjustment menu value and the screen state may not match until the adjustment begins.
Related Topic
Parts and Controls (Remote Commander and Control Panel)
Menu Operation: H Keystone
/
/
/
(Up/Down/Left/Right) keys.
5-014-280-13(1) Copyright 2020 Sony Corporation
35
[Installation] menu.