Help Guide
Data Projector
VPL-CWZ10/CXZ10
Setting ADCP
Change the ADCP control protocol settings from the [ADCP] page.
Note
The entered value will not be applied until [Apply] is clicked.
Click the [ADCP] tab and display the [ADCP] page.
1
Configure each item and click [Apply].
2
Settings
[Start ADCP Service]
Turn ADCP on or off. The settings related to ADCP are applied only if it is on. It is off in the default factory setting.
[Requires Authentication]: Turn the ADCP authentication function on or off. The web page administrator password is
set for the password.
[Port No.]: Enter the ADCP server port. The default factory setting ADCP server port is "53595."
[Timeout]: Enter the time (in seconds) until the connection is cut when ADCP communication is interrupted. The time
in the default factory setting is "60."
[Host Address]: Enter the IP address allowed to be received by the ADCP server. If nothing is entered, commands
can be received from any IP address. Once an IP address has been entered, access will only be allowed from the
entered IP address. For security purposes, we recommend entering an IP address and restricting access.
5-014-280-13(1) Copyright 2020 Sony Corporation
103