Table of Contents
Advertisement
Help Guide
Data Projector
VPL-CWZ10/CXZ10
Setting Advertisement
Change the Advertisement control protocol settings from the [Advertisement / PJ Talk / PJ Link] page.
Note
The entered value will not be applied until [Apply] is clicked.
Click the [Advertisement / PJ Talk / PJ Link] tab and display the [Advertisement / PJ Talk / PJ Link] page.
1
Configure each item under [Advertisement] and click [Apply].
2
Settings
[Start Advertisement Service]
Turn Advertisement on or off. The settings related to Advertisement are applied only if it is on. It is off in the default
factory setting.
[Community]: Enter the community names for Advertisement and PJ Talk. If changed, the PJ Talk community name
changes as well. Only entries consisting of four alphanumeric characters are allowed. The default factory setting
community name is "SONY." To avoid unauthorized access to the projector from another computer, we recommend
changing the community name from the one in the factory setting.
[Port No.]: Enter the Advertisement transmission port. The default factory setting Advertisement transmission port is
"53862."
[Interval]: Enter the Advertisement transmission interval (seconds). The Advertisement transmission interval in the
default factory setting Advertisement transmission port is "30."
[Broadcast Address]: Enter the Advertisement data transmission recipient. If nothing is entered, it will be broadcast
on the same subnet.
5-014-280-13(1) Copyright 2020 Sony Corporation
100
Advertisement
Table of Contents
