Advertisement
Connect to Console Port
1. Connect the RJ45 end of the console cable to the console port of
switch.
2. Connect the other end of the console cable to the DB9 male connector
or USB port to the PC.
INSTALLATION
Install on the Desktop
1. Place the bottom of switch on a sufficiently large and stable table.
2. Peel off the rubber protective paper of the four footpads one by one,
and stick them in the corresponding circular grooves at the four
corners of the bottom of the case.
3. Flip the switch over and place it smoothly on the table
Rubber footpads
Back of the Switch
Circular groove
~ 9 ~
Install on the Wall
1. Use the matching screws (KM 3*6) to fix the two L-shaped rack-
mounting kits (rotated 90°) on both sides of switch.
2. Stick the switch port up and horizontally on the selected wall, mark
the position of the screw hole on the L-shaped rack-mounting kits with
a marker. Then, drill a hole at the marked position with an impact drill,
and drill the expansion screws(prepared by yourself) into the drilled
hole in the wall.
3. Use a screwdriver to tighten the screws(prepared by yourself) that
have passed through the L-shaped rack-mounting kits to tighten the
expansion solenoids to ensure that the switch is firmly installed on
the wall.
Install on a 19" Standard Rack
Note:
GWN7802/GWN7802P/GWN7803/GWN7803P support rack
mounting.
1. Check the grounding and stability of the rack.
2. Install the two L-shaped rack-mounting in the accessories on both
sides of switch, and fix them with the screws provided (KM 3*6).
~ 10 ~
Advertisement
