Cannot Print From Digital Camera Using Pictbridge; Resetting To Factory Default Settings - Lexmark 5400 Series Setup

May need to reconnect
power supply
Software may not be
installed correctly

Cannot print from digital camera using PictBridge

Enable PictBridge printing
from camera
Make sure the camera is
PictBridge-enabled
Check USB cable
Remove memory cards
Check messages

Resetting to factory default settings

You can reset your printer to the original settings without using the printer menus.
Note: Resetting to factory default settings will delete all printer settings you selected, including Speed Dial and Group
Dial numbers.
1
Press , , and Start Color at the same time.
Warning—Potential Damage: Do not release the buttons until Language appears on the display indicating
that the printer has been reset.
2
Follow the prompts on the display to choose your language, country or region code, date, time, and fax number.
1
Press to turn the printer off.
2
Disconnect the power cord from the wall outlet.
3
Gently remove the power supply from the printer.
4
Reconnect the power supply to the printer.
5
Plug the power cord into the wall outlet.
6
Press to turn the printer on.
1
Uninstall the printer software, and then reinstall it. For more information, see
"Removing and reinstalling the software" on page 25.
2
If the software still does not install correctly, visit our Web site at
www.lexmark.com to check for the latest software.
a
In all countries or regions except the United States, select your country or region.
b
Click the links for drivers or downloads.
c
Select your printer family.
d
Select your printer model.
e
Select your operating system.
f
Select the file you want to download, and then follow the directions on the
computer screen.
Enable PictBridge printing on the camera by selecting the correct USB mode. For more
information, see the digital camera documentation.
1
Disconnect the camera.
2
Connect a PictBridge-enabled digital camera to the PictBridge port. See the digital
camera documentation to determine whether it is PictBridge-enabled.
Use only the USB cable that came with the camera.
Remove any memory cards from the printer.
If an error message is displayed, see "Error messages" in the "Troubleshooting" chapter
of the User's Guide.
24