Key Automation TURBO 400 Instructions And Warnings For Installation And Use page 12

EN
6.11 - Connection of the LIGHT
LIGHT 230 Vac
9 11
7 - OPERATING AND REGULATION MODES
The control board has several micro-switches to activate a lot of functions in order to find suitable solutions for the user and to make the
installation more safety.
7.1 - Logic Function
3 4 5 6
1 2 7 8
3
1 2 4 5 6 7 8
3 4 5 6 7 8
1 2
3 4 5
1 2 6 7 8
3 4 5
1 2 6 7 8
3 4 5 6 7 8
1 2
3 4 5 6
1 2 7 8
3 6
1 2 4 5 7 8
3 4 5 6 7 8
1 2
3 4 5 6 7
1 2 7 8
1 2 3 4 5 6 7 8
12
If
photo-test or the signal light,
you cannot use this connection.
1 2 3 4 5 6 7 8 9 10
1-OFF 2-OFF
9 10
1-ON 2-OFF
COLLECTIVE USE
9 10
1-OFF 2-ON
9 10
1-ON 2-ON
9 10
3-ON
9 10
4-OFF
9 10
4-ON
9 10
6 se DIP 4 OFF
9 10
6 se DIP 4 ON
9 10
7-ON
9 10
9-ON 10-ON
9 10
6
you prevue to use the
DIP
By each control it reverse. It recluse automatically at the end of
AUTOMATIC 1
the pause time.
When opening and in pause time it doesn't accept any control, it
reclose automatically at the end of the pause time.
PARTIALLY Each control the sequenze is OPEN-STOP-CLOSE-STOP etc.
AUTOMATIC It doesn't reclose automatically.
By each control the sequence is OPEN-STOP-CLOSE-STOP
AUTOMATIC 2
etc. It reclose automatically at the end of the pause time
Dead Man
"DEAD MAN" function activate
Function
DIP4 OFF if in the terminal board no.15 and 16 is connected to
Lamp
a SIGNAL LIGHT
External DIP 4 ON If the terminal board no.15 and 16 is connected to a
Brake
mechanic brake.
Pre-lightin It activate the pre-lighting before the gate's moving
exterior
Put the DIP in ON if the brake has been activated
brake or in OFF if it is activated when it is not powered.
Internal To activate the electronic brake put DIP 7 IN on. WARNING!!!
Brake
The inside brake is activated for a while after the motor stops
If you put the DIP 9 and 10 in ON, you can activate the radio
Radio partial
partial opening (10 poles molex connector).
opening
If you use this function, terminal boards OUT2 should be free.
LIGHT 24 Vac
7
Par. 3.2