Safety Instructions, Precautions And Hazards; General - EFD MINAC 25 Twin User Manual

MINAC Systems
USER MANUAL
63860.doc
2

SAFETY INSTRUCTIONS, PRECAUTIONS AND HAZARDS

2.1

General

Safety instructions, including important information concerning the risks associated
with specific operations and recommendations on suitable precautions, are found
throughout the handbook where appropriate. The safety instructions are divided into
the two categories Warnings and Cautions:
Safety precautions must be observed during all phases of operation and
maintenance. Failure to comply with these precautions, or with specific WARNINGS
and CAUTIONS given elsewhere in this handbook, is a violation of the safety
standards of the design, manufacture and intended use of the equipment.
All personnel operating, maintaining or working in close proximity to the equipment
MUST thoroughly read, understand and obey the safety instructions that apply to this
equipment given by EFD Induction a.s. Only properly trained personnel who are
familiar with the technical handbook should be permitted to open the covers for
servicing this equipment.
Please note the following:
• To avoid personal injury, do not remove the equipment's covers or panels. Do
not, under any circumstances, operate the equipment without the covers and
panels properly installed.
• Switch off the equipment's power supply when it is not in use, and always retract
the mains plug prior to repair or maintenance.
• Always comply with all safety measures when handling electrical equipment,
including any national or international regulation.
© For reproduction rights, see cover page.
Warning statements identify conditions or practices
that could result in injury or loss of life.
Caution statements identify conditions or practices
that could result in damage to equipment and
surroundings.
Comply with all safety instructions. Failure to do so
can result in serious personal injury or damage to
equipment and surroundings.
Revision A
31 January 2005
WARNING!
CAUTION!
WARNING!
Page 2