Display Values (Menu 24); Display All Values (Menu 19); Display Timer/Sequence (Menu 23); Display Twin Values (Menu 36) (Only Twin Units) - EFD MINAC 25 Twin User Manual

MINAC Systems
USER MANUAL
63860.doc
5.2.9

Display Values (menu 24)

This menu provides information on normal operational values. It displays a
continuous graphical presentation of AC current and DC power. The programmed
setpoint is marked on the bar graph representing the selected mode of operation.
The AC current frequency is indicated on the right upper side of the AC current bar
graph. Return to the Main Menu by pressing F9. The Display Values Menu also
contains a "Display All Values" sub-menu. Press F0 to call up this menu.

5.2.10 Display All Values (menu 19)

This menu shows all normal operational values in the form of bar graphs. These
values are AC current, DC power, DC voltage and DC current. The bar graph
representing the value selected as the mode of operation is marked with the setpoint
value. Return to the previous menu by pressing F9.

5.2.11 Display Timer/Sequence (menu 23)

This menu provides a continuous graphical presentation of the current sequence or
timer function (time is given as a relative value). Only one of these functions is
shown since they are mutually exclusive. This menu also shows the bar graph
representing the value selected as the mode of operation (AC current or DC power).
The setpoint is marked on the bar graph. If energy supervision is activated, a
"smiley" will show whether the energy check result is OK or not.
OK:
Return to the Main Menu by pressing F9.

5.2.12 Display Twin Values (menu 36) (Only Twin units)

This menu provides information on operational values of both outputs in Twin units.
The menu is split horizontally into two parts, with the upper part showing information
related to output 1 and the lower part correspondingly to output 2. Each part displays
a graphical presentation of AC current and DC power, and indicates the setpoint and
AC current frequency. A footer message, of the type found in the other menus, is at
the bottoms of both the upper and lower parts. The output number is displayed to the
right of each footer message. Return to the Main Menu by pressing F9.

5.2.13 Status menu F7 (menu 29)

This menu displays the following parameters.
• Water flow (dl/min)
• Water temperature (°C)
• Output current frequency (kHz)
• Up to 6 active alarms, if any.
Return to the Main Menu by pressing F9.
© For reproduction rights, see cover page.
J
LOW/HIGH:
Revision A
31 January 2005
L
Page 22