EFD MINAC 25 Twin User Manual page 12

MINAC Systems
USER MANUAL
63860.doc
Table 2. Switches and Indicators, and Functions
Key Type
AUX Voltage indicator
Ready indicator
Failure indicator
Local/ Remote indicator
Power off switch
Power on switch
Reset switch
Loc./ rem. switch
HHT1 indicator
HHT2 indicator
(Twin units only)
Control Select switch
(Twin units only)
© For reproduction rights, see cover page.
Figure 6. Switches and Indicators
Indicates that the voltage for the auxiliary circuits is on.
Indicates that the MINAC system is ready for use.
Indicates that some fault condition is present. This will block
the power-on function until the alarm system is reset.
Show if the unit is to be controlled from the operating panel or
via the external control plugs.
Switches the output power off.
Switches the output power on. This button has an indicating
light that is lit when the output power is on.
Resets the alarm system when a fault condition is no longer
present.
Toggles the operation mode of the unit.
Indicates that the operating panel keys are valid for HHT1
output.
Indicates that the operating panel keys are valid for HHT2
output.
Allows the operator to switch between HHT1 and HHT2. The
HHT selected is the one operated by the operating panel and
the one displayed on the MMI display.
Revision A
31 January 2005
Function
Page 9