Change Pin Code Menu (Menu 27); Setpoint Menu (Menu 3) - EFD MINAC 25 Twin User Manual

MINAC Systems
USER MANUAL
63860.doc
5.2.3

Change PIN code Menu (menu 27)

This menu allows the operator to change the PIN code.
First enter the old PIN code and then enter the new PIN code twice:
Give old PIN code:
Give new PIN code:
Retype new PIN code:
Return to the previous menu by pressing F9.
5.2.4

Setpoint Menu (menu 3)

This menu is used to select the mode of operation (type of regulation). Only one of
the first three modes in the list can be activated at a time (mutually exclusive
functions). In addition, this menu contains a function for selecting the setpoint source
and signal type to/ from the external control.
F0 AC Current
F1 DC Power
F2 Temperature
F3 Setpoint source
F6 Ext. signal select
F7 Ext. setpoint signal type
F8 Ext. feedback signal type
Return to the Main Menu by pressing F9.
Setpoint source
The four options given in function F3 "Setpoint source" have the following definitions:
LOC
EXT
HHT
DEFAULT
If HHT handle is not equipped with a power control device make sure not to select
HHT as Setpoint source as this will result in zero setpoint value.
© For reproduction rights, see cover page.
<0-9999>
<0-9999>
<0-9999>
Setpoint from the control panel "up" and "down" arrows.
Setpoint from an external device.
Setpoint from the HHT setpoint control.
Setpoint from the source where the power-on command is detected.
Revision A
31 January 2005
<ACTIVE/OFF>
<ACTIVE/OFF>
<ACTIVE/OFF>
<LOC/EXT/HHT/DEFAULT>
<DC power/AC current/DC
voltage/Frequency/Temperature>
<0-10V/0-20mA/4-20mA>
<0-10V/0-20mA/4-20mA >
Page 14