Table of Contents
Advertisement
1.3
SYSTEM WATER PRESSURE
The system pressure gauge, behind the drop down door, indicates the central heating system
pressure. If the pressure is seen to fall below the original installation pressure of 1-2 bar
over a period of time and continue to fall then a water leak may be indicated. In this event
re-pressurise the system as shown below. If unable to do so or if the pressure continues to
drop a Gas Safe Registered Engineer.
THE BOILER WILL NOT OPERATE IF THE PRESSURE HAS REDUCED TO LESS
THAN 0.3 BAR UNDER THIS CONDITION.
1.4
POINTS FOR THE BOILER USER
Note. In line with our current warranty policy we would ask that you check through the following guide to identify any problems
external to the boiler prior to requesting a service engineers visit. Should the problem be found to be other than with the appliance
we reserve the right to levy a charge for the visit, or for any pre-arranged visit where access is not gained by the engineer.
FOR ANY QUERIES PLEASE RING THE IDEAL CONSUMER HELPLINE : 01482 498660
BOILER RESTART PROCEDURE - To restart boiler press the restart button
1.5
CONDENSATE DRAIN
This appliance is fitted with a siphonic condensate trap
system that reduces the risk of the appliance condensate
from freezing. However should the condensate pipe to this
appliance freeze, please follow these instructions:
a. If you do not feel competent to carry out the defrosting
instructions below please call your local Gas Safe
Registered installer for assistance.
b. If you do feel competent to carry out the following
instructions please do so with care when handling hot
utensils. Do not attempt to thaw pipework above ground
level.
If this appliance develops a blockage in its condensate pipe,
its condensate will build up to a point where it will make a
gurgling noise prior to locking out displaying "Ignition Lockout"
on the display. If the appliance is restarted it will make
a gurgling noise prior to it locking out displaying "Ignition
Lockout" on the display.
To unblock a frozen condensate pipe;
1. Follow the routing of the plastic pipe from its exit point on
the appliance, through its route to its termination point.
Locate the frozen blockage. It is likely that the pipe is
frozen at the most exposed point external to the building
or where there is some obstruction to flow. This could be
at the open end of the pipe, at a bend or elbow, or where
there is a dip in the pipe in which condensate can collect.
The location of the blockage should be identified as closely
as possible before taking further action.
User Guide
1 bar
Min
2. Apply a hot water bottle, microwaveable heat pack or a
warm damp cloth to the frozen blockage area. Several
applications may have to be made before it fully defrosts.
Warm water can also be poured onto the pipe from a
watering can or similar. DO NOT use boiling water.
3. Caution when using warm water as this may freeze and
cause other localised hazards.
4. Once the blockage is removed and the condensate can
flow freely, restart the appliance. (Refer to "To Start the
boiler")
5. If the appliance fails to ignite, call your Gas Safe
Registered engineer.
Preventative Solutions
During cold weather, set the central heating temperature knob
(B) to "MAX", (Remember to return to original setting once
cold spell is over).
Place the heating on continuous and turn the room thermostat
down to 15ºC overnight or when unoccupied. (Return to
normal after cold spell).
2 bar
Max
2
1
3
0
4
bar
SCAN
for video
5
Advertisement
Table of Contents
