Connection Terminals Of Camera Control Unit (Ccu); Performances /Functions - Siemens MULTIMOBIL 5C Troubleshooting Manual

Aspect ratio
Video output
Lens mount
Input power
Power consumption
Environmental
Operation
Storage &
Transportation

6.3 CONNECTION TERMINALS OF CAMERA CONTROL UNIT (CCU)

CAMERA (D-sub15)
VIDEO OUT 1 and 2 (BNC)
REMOTE CONTROL 1 [36-
pin(D57;DDK)]
REMOTE CONTROL 2 (D-sub25)
HD OUT (BNC)
VD OUT (BNC)
AC100-240V
FG
CONT (D-sub9)

6.4 PERFORMANCES /FUNCTIONS

CCD operation method
Resolution
S/N ratio
Frequency response
Aperture correct. (AP)
Siemens Ltd. Med India
4:3
VS 1.0 V / 75 Ohm BNC connection, 2 routes
C mount
Single-phase, 100 - 240V, 50 or 60Hz
30 W approx.
Temperature Humidity
30-75% RH max.
+10 to +40 °C
95% RH max.
-15 to 45 °C
Connected to the camera head with the camera
cable.
Digital Video signal: LIH image, Memory image.
Monitor is connected to this terminal.
Input/output of the one signal group for external
control of camera.
Input/output of the other signal group for
external control of camera.
Horizontal drive pulse output for external
devices
Vertical drive pulse output for external devices
AC power input.
Grounding terminal.
For camera control with RS232c.
Frame accumulation
(CCIR) 560 TV lines (H) 520 lines (V) or more
for frame accumulation
55dB or more (under Normal gain, AP;OFF, γ
;1, Using 4.2 MHz low pass filter)
0 to 8 MHz (-3dB)
Front & rear edge emphasis for both H&V. AP
ON/OFF & emphasis level are selectable
Copyright © SIEMENS LTD. All rights reserved. For internal use only
Service Instructions
Air pressure
70 – 106 kPa (no
condensation)
76 – 106 kPa (no
condensation)
Version 5.0
Multimobil 5C
Page 30 of 73