Stopping The Engine; Alternating Current (Ac) Connection - CAMPAGNOLA ENERGY4 Use And Maintenance Manual

WARNING!
4- Slowly pull the recoil starter handle ② until it engages, then pull it quickly to start the engine.
The choke is not required to start a warm engine. Push the choke knob in to the position "OPEN".
Grasp the carrying handle ① firmly to prevent the generator from falling over when pulling the recoil starter.
WARNING!
5- After the engine starts, warm up the engine until the engine does not stop when the choke lever is turnedto the
"OPEN" position.
6.2

Stopping the engine

WARNING!
- Before stopping the Generator engine, turn off all connected electrical devices.
- Turn the generator switch to the "OFF" position (see par. 4.7).
- Turn the fuel tap to the "0" CLOSE position.
The ignition circuit is off, the fuel is closed.
- After the engine has completely cooled down, turn the air vent knob to "OFF" - 1.
6.3

Alternating Current (AC) connection

WARNING!
- Make sure all electrical devices are turned off before connecting them to the Generator.
- Be sure ali electric devices including the Iines and plug connections are in good condition before connection
to the generator.
- Be sure the total load is within generator rated output.
Be sure the receptacle load current is within receptacle rated current.
-
NOTE: if the Generator is connected to the 220 V AC mains, the Generator must also be connected to earth via
the Earth terminal (see par. 4.11).
Page 34
Use and maintenance manual – Translation of
original Instruction Rev.: 01, Date 02/11/2022