Power Switch; Preamplifier Outputs; Dock Connector; Ac Input Connector - Lexicon MV-5 User Manual

MV-5

11. POWER SWITCH

Use the Power Switch to connect or disconnect power from the AC
Input connector to the MV-5 Processor. When the MV-5 is powered
on, the front panel Standby button or remote control ON & OFF
buttons can be used to activate and deactivate standby mode. When
the MV-5 is powered off via the rear panel switch, the standby and
ON modes are not available.

12. AC INPUT CONNECTOR

Provides power to the MV-5 through the supplied power cord.

13. TRIGGER OUTPUT CONNECTORS

Provide a 12V DC output to control connected components. Two
trigger output connectors are available as 3.5 mm mono mini
phone jacks. The OUT 1 connector is the power trigger and is not
configurable; it is activated when the MV-5 is powered on or taken
out of Standby mode, and deactivated when the MV-5 is powered
off, either from the rear panel or by putting the MV-5 into Standby
mode. The OUT 2 connector can be configured independently for
each input, refer to Section 3: Setup for more information on how to
configure the OUT 2 trigger.
Note: The OUT 2 trigger is referred to as "TRIGGER 2" in the Input Setup
menu.

14. RS-232 CONNECTOR

The RS-232 serial connector provides serial remote control through a
standard RS-232 connection. Refer to the Lexicon website
(www.lexicon.com) for more details on controlling the MV-5 Processor
via the RS-232 connection.

15. PREAMPLIFIER OUTPUTS

Provide output for external power amplifiers for applications that
require them.

16. DOCK CONNECTOR

Provides an interface for an iPod, which can then be accessed
through the MV-5 rear panel. To use this feature, the D-1 Dock
option must be installed to the DOCK connector. With a
compatible iPod connected to the MV-5, selecting the DOCK input
allows you to play audio files from the iPod. You can view and
navigate through the iPod menus using the MV-5 remote control.
For more information on the Dock option and how to use your
MV-5 with an iPod, refer to Section 5: PC & Dock Controls.

17. ZONE 2 AUDIO OUTPUT CONNECTORS

Provide preamplifier audio outputs for Zone 2.

18. STEREO ANALOG AUDIO INPUT CONNECTORS

Provide stereo analog audio input. Six stereo analog audio input
RCA connectors labeled 1 to 6 are available.

19. MICROPHONE INPUT CONNECTOR

Provides a microphone input for system calibration. The
microphone input is only for use with the supplied microphone
during the system calibration process. See Section 3: Setup for more
information regarding system calibration and setup.
Basic Operation
2-7