Installation Considerations; Remote Control Battery Installation - Lexicon MV-5 User Manual

Getting Started

INSTALLATION CONSIDERATIONS

The MV-5 requires special care during installation to ensure optimal
performance. Pay particular attention to the instructions below and
to other precautions that appear throughout this user guide.
D
install the MV-5 on a solid, flat, level surface such as a table or
O
shelf.
D
select a dry, well-ventilated location out of direct sunlight.
O
D N
expose the MV-5 to high temperatures, humidity, steam,
O OT
smoke, dampness or excessive dust. Avoid installing the MV-5 near
radiators or stacking the MV-5 over other heat-producing
equipment such as a power amplifier.
D N
place the MV-5 on a thick rug or carpet, or cover the RV-5
O OT
with a cloth, as this might prevent proper cooling.
D N
O OT place the MV-5 on a windowsill or any location exposed
to direct sunlight.
D N
O OT obstruct the front panel IR receiver window. The remote
control must be in line of sight with the IR receiver for proper
operation (unless using the optional RF-1 Receiver).
D N
O OT install the MV-5 on a surface that is unstable or unable to
support all four feet.
CAUTION!
Before moving the MV-5, power the unit off using the rear
panel power switch and unplug the power cord from the
wall outlet.
1-4
REMOTE CONTROL BATTERY
INSTALLATION
The remote control requires four AAA batteries. The batteries
should be replaced as needed. Alkaline batteries, which last longer
without leaking, are recommended. When battery power is low, the
remote control enters a low-voltage condition, preventing it from
operating the MV-5. When this occurs, replace the batteries.
Normal operation will resume when new batteries are installed.
Note: The Remote Control will not lose any custom settings if the batteries
run out. All custom settings are stored in non-volatile FLASH memory.
To replace the remote control batteries:
1. Locate the battery compartment on the back of the remote
control. Press the tab and lift the cover away from the remote
control.
2. Remove old batteries, if applicable.
3. Observing the proper polarity, insert four AAA batteries.
4. Align the cover over the battery compartment and gently press
down until it snaps back into place.
5. Properly dispose of the old batteries.
Lexicon