Table of Contents
Advertisement
Service Diagnostics and Procedures–Disassembly
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power to unit using power
switch before servicing. Wires removed during disassembly must be replaced on proper terminals to insure
correct earth ground and polarization. After servicing, reconnect power using power switch.
Dispenser Bezel
1. Press tabs with blade to disengage bezel
assembly from dispenser housing.
Tabs
2. Lift bezel assembly up and out.
© 2010 Viking Preferred Service
WARNING
3. Disconnect wiring from user interface board.
4. From inside of bezel, remove two screws to
release user interface board.
Screw
5. Repair or replace user interface board.
6. Reverse procedure to reinstall.
Wiring
50
Advertisement
Table of Contents
