Table of Contents
Advertisement
Service Diagnostics and Procedures–Disassembly
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power to unit using power
switch before servicing. Wires removed during disassembly must be replaced on proper terminals to insure
correct earth ground and polarization. After servicing, reconnect power using power switch.
Water Fitting, Ice Guide,
Ice and Water Paddle Assemblies (cont.)
4. Remove right screw and slide tube out to
remove water fitting.
\\\
Water Fitting
Water Tube
5. Disconnect delay and remove ice guide by
pulling outward.
Ice Guide
© 2010 Viking Preferred Service
WARNING
6. Remove center screw and retainer to remove
ice and water paddle assemblies.
Screw
7. Repair or replace.
8. Reverse procedure to reinstall.
Delay
Retainer Clip
Screw
52
Advertisement
Table of Contents
