Agilent Technologies ESA-E Series User Manual page 26

Making Measurements
Making Cable Fault Measurements
Figure 3-3 Cable Fault Location Measurement Setup
NOTE The distance-to-fault accessory kit, Option B7K, has all the 50 ohm accessories
required to make these measurements.
accessories required for 50 ohm and 75 ohm measurements.
20
c. Press .
Calibrate
For a 50 ohm setup, connect a load to the analyzer via the power divider as
prompted. See Figure
power splitter open.
d. Press . Your setup is now calibrated.
Continue
Connect a DUT (device under test).
e. Press .
Continue
* 50 ohm only. The 6 dB attenuators may be used to improve impedance matching.
** 75 ohm only.
3-1. For a 75 ohm setup, leave the output port of the
Table 3-1 on page 17 lists the cables and
Chapter 3