Agilent Technologies ESA-E Series User Manual page 13

8
9
10
11
12
13
Table 1-1 Installer Status Messages
Failed
Loading
Verifying
Loaded
Installed
Skipping
Chapter 1
Processing item shows the file that is being processes by item number.
Bytes free on C is the number of bytes currently free on the instrument C: drive.
Status Bar contains a status bar that runs from 0 to 100% and tracks the progress
of the current step. A message line displays the step that is currently being
executed.
Bytes in package lists the number of bytes in the install package file.
Bytes left in package lists the number of bytes left to be read.
Message and error popup window that displays over the status bar. Information in
this box will prompt you for action required to proceed to the next phase of the
installation. It may also inform you of errors in the installation process and may
prompt you for action required to correct the problem.
This means that something has gone wrong while processing this item. It
is a fatal error and the installation can not be completed. The installer
will try to get the system back to a good state which may entail
completely removing the currently installed personality.
The file is currently being copied from the install media to the
instrument's file system.
This may mean one of two things:
1. If "Verify Disks" was pressed then Verifying means that the installer
is currently reading the install media and comparing the known
checksums to ensure the data is good.
2. If "Install Now" was pressed, then Verifying means that the installer
is reading what was just loaded to ensure the checksum is correct.
This means that the data has been placed on the instrument disk but has
not yet been registered with the firmware.
This means that the data has been loaded into the instrument and
registered. The install for this file is complete.
This means that the installer has determined that this file does not need
to be loaded into the instrument.
Installing the Optional Measurement Personality
Getting Started
7