Agilent Technologies ESA-E Series User Manual page 25

Figure 3-2 Cable Type Selection Screen
3. Set up a maximum range value just greater than the length of the cable to be
4. If required, set up a start distance offset to be used when displaying the trace
NOTE The above steps may cause the trace-points parameter to be changed. To prevent
this from happening, change this parameter to manual before attempting steps 2
through 4. If you choose to override this parameter, the resultant trace may appear
discontinuous.
5. Calibrate the spectrum analyzer.
Press the
NOTE
Chapter 3
tested:
a. Press the
Stop Distance
b. Enter the appropriate value using the numeric key pad.
and calculating distances:
a. Press the
Start Distance
b. Enter the appropriate value using the numeric key pad.
Calibration removes any errors introduced by the cabling and components of
the test setup before making the measurement.
front panel key to cancel this procedure at any stage.
Esc
a. Disconnect the cable to be tested.
b. Press the
Meas Setup
Making Cable Fault Measurements
menu key.
menu key.
front-panel key.
Making Measurements
19