Newco CX-TOUCH Operation Manual page 15

Custom Logo--Wi-Fi Setup
SETTING UP A CUSTOM LOGO SCREEN REQUIRES A WI-FI CONNECTION TO THE CX-TOUCH MACHINE.
NOTE THAT AFTER THE LOGO IS INSTALLED, THE WI-FI CONNECTION MUST BE TURNED BACK TO "OFF" STATUS.
UPDATES THAT MAY OCCUR IF WI-FI IS LEFT ON WILL CAUSE OPERABILITY ISSUES WITH THE BREWER.
ACCESS THE BREW SELECTION SCREEN
TAP THE "TEA & WATER" BAR 3 TIMES TO
ENTER PROGRAMMING MODE. - IF A BREWING
ICON IS ACCIDENTLY TOUCHED USE THE
RETURN ARROW TO TRY AGAIN
CHOOSE INSTALL LOGO
SELECT LOCAL SETUP FROM PROGRAMMING MENU
AND THEN CHOOSE NETWORK SETUP. THIS WILL TAKE
YOU TO THE ANDROID SETTINGS SCREEN WHERE YOU
WILL BE ABLE TO CONNECT TO WI-FI NETWORK.
MACHINE. NOTE THAT IT IS USED FOR THE
COMMUNICATION WITH ANOTHER DEVICE
SELECT WI-FI FROM THE SETTINGS
SCREEN. TURN WI-FI ON. SELECT
THE NETWORK WHEN IT APPEARS.
ONCE CONNECTED, YOU WILL NEED
TO TURN POWER TO THE BREWER
OFF AND THEN BACK ON AGAIN TO
EXIT THE ANDROID SETTINGS MENU
PROGRAMMING SCREENS. POWER
TABLET REBOOTS, ENTER THE LOCAL
THIS ADDRESS IS UNIQUE FOR EVERY
HOST ADDRESS WHEN SETTING UP
TO TRANSFER LOGO (SEE NEXT PAGE).
ENTER THE PASSWORD AND
CONNECT.
AND RETURN TO THE CX
SWITCH IS ON THE LOWER RIGHT
REAR OF BREWER. WHEN THE
SETUP SCREEN AS DESCRIBED AT
LEFT.