Advertisement
Secure the Spout 固定龙头
1-1/4" OD
- Feed the cables and tubes from the spout through the
mounting bracket and down through the PVC tubing.
- Slide the spout assembly onto the mounting pin until flush
with the wall.
- Pull the cables and tubes from the spout out through the
hole leading to the control box location.
- Tighten the two setscrews (provided) to secure the
spout to the mounting bracket.
Install the Control Box
- Mark the location of the mounting holes.
- Attach the control box to the wall as shown.
- Secure with the four screws provided.
1434862-T01-D
Finished Wall
表面处理过的墙壁
- 将从龙头引出的电缆和导管穿过托架， 然后向下穿过PVC管。
- 将龙头组件滑到安装销上， 直至与墙壁齐平。
- 将从龙头引出的电缆和导管穿过通向控制盒位置的孔洞。
- 拧紧两个固定螺钉 （随机提供） ， 将龙头固定到托架上。
安装控制盒
标记安装孔的位置。
如图所示将控制盒放置在墙壁上。
使用随机提供的四个螺钉进行固定。
7
1-1/4" OD
Advertisement
