Advertisement
Connect the Control Box Wires
感应器
组件电
缆
塑料管
- IMPORTANT! Verify that the cables are not pinched
when connecting to the control box.
- IMPORTANT! The area in front of the sensor must be
free of objects during the 2 minute learning cycle or the
soap dispenser may not function properly.
- Connect the sensor cable from the spout to the sensor
cable from the control box.
- Connect the LED cable from the spout to the LED cable
from the control box.
- Connect the power supply connector from the battery
box to the power supply connector from the control box.
- Allow 2 minutes for the sensor to cycle through the
automatic sensing distance.
- NOTE: Once the power supply cords are connected
the base of the soap dispenser will lash red twice every
six seconds. This is normal and is a signal that there is
no soap in the reservoir. After the soap is illed and primed
the lashing will stop.
- Secure any extra wire under the counter.
1434862-T01-D
连接控制盒电线
组件电缆
塑料管
感应器组件连接器
电源连接器
- 重要！ 确保连接至控制盒电缆没有被夹住。
- 重要！ 在2分钟的学习循环内， 感应器前方区域不得有任何物
体， 否则皂液器可能无法正常工作。
- 将龙头的感应器电缆与控制盒的感应器电缆相连接。
- 将龙头的LED电缆与控制盒的LED电缆相连接。
- 将电池盒的电源连接器与控制盒的电源连接器相连接。
- 等待2分钟， 让感应器在自动感应距离内循环。
- 注意： 连接电源线后， 皂液器的底座每六秒钟闪烁两次红光。
这属于正常现象， 说明皂液瓶中没有皂液。 装满皂液并起动后，
灯光闪烁停止。
- 将多余的电线固定在洗手台下面。
9
电源连接器
连接器
气泵出口
皂泵出口
2P female
connector
2P母线
2P male
connector
2P公线
AC power
AC电源
接头
接头
Advertisement
