Install The Control Box - Kohler Kumin K-104K37-SANA-CP Installation Instructions Manual

2. Install the Control Box

G1/2 Inlet
NOTE: Verify that the flex hose can be connected to the supply stop and the control
box inlet before attaching the control box to the wall.
NOTE: Refer to the Specification Sheet to determine the control box installation
location.
Position the control box below the deck and mark the locations for the mounting
holes.
Verify that the sensor cable is below the countertop.
Drill 1/8" (3 mm) pilot holes.
Use the standard wall anchors (provided) depending on your wall material.
Attach the control box to the wall with the arrow pointing upward. Secure with
the two screws (provided).
Unthread the control box screws to remove the cover.
Kohler Co.
Mounting Holes
Filter
Screen
7
1561532-2-A