Xylem Aquavar AB2 Quick Start Manual

Aquavar AB2
Quick Start Up Guide
LABELS FOUND ON THE CONTROLLER ACCESS COVER:
Motor Overload Setting
WARNING: Disconnect Power And Wait For LED Indicator To
Turn Off Before Touching Motor Overload Setting Switches.
1 = UP
DIP Switch Setting
1 2 3 4
1 1 1 1
1 1 1 0
1 1 0 1
1 0 1 1
0 1 1 1
0 0 0 0
Motor Overload Setting Label
Use this label to choose the correct Motor Overload Switch
Setting. This label is found under the controller access cover.
Use this label to diagnose any system errors. This label is
found on the side of the controller access cover.
WARNING: Disconnect Power And Wait For LED Indicator To Turn
Off Before Touching Application Setting Switches.
DIP Switch Setting
1 2 3 4
1 1 1 1 *
1 1 1 0 *
1 1 0 1 *
1 0 1 1
0 1 1 1
0 0 0 0
*THESE SETTINGS ARE NOT TO BE USED WITH SUBMERSIBLE PUMPS.
0 = DOWN
Motor Overload Setting (Amps)
1AB2
2.5
2.8
3.3
3.5
3.8
4.2
Status Code Label
Application Switch Setting
1 = UP
Minimum Speed (Hz)
10
10
10
30
30
30
Constant Standby/Low Voltage
Blinking
2AB2
Constant Replace Controller
4.6
1 Blink
5.2
2 Blinks
5.3
3 Blinks
5.8
4 Blinks
6.5
5 Blinks
6.9
6 Blinks
7 Blinks
8 Blinks
9 Blinks
*No Light - No/Very Low Voltage
0 = DOWN
Ramp Setting
Medium
Medium
QUICK START GUIDE
IMS-AB2-2
Fault Codes
Status Codes*
Green Light Codes
Pump Running
Red Light Codes
No Water/Loss Of Prime
Tank Water-Logged
Pressure Sensor Fault
Pump or Motor Bound
Short Circuit
Ground Fault
High Temperature
Over Voltage (>264V)
Motor Overload
Application
Switch
Setting
Label
Use this label
to choose
the correct
Slow
Application
Switch Setting.
Fast
This label is
Slow
found under
the controller
Fast
access cover.