Troubleshooting - Toro 51810T Manual

Troubleshooting

Perform only the steps described in these instructions. All further inspection, maintenance, and repair work
must be performed by an authorized service center or a similarly qualified specialist if you cannot solve the
problem yourself.
Always remove the battery from the tool when troubleshooting, inspecting, maintaining, or cleaning the tool.
Problem
The tool does not run or does not run
continuously.
The tool does not reach full power.
The tool is producing excessive vibration
or noise.
The battery pack loses charge quickly.
Possible Cause
1. The battery is not fully installed in the
tool.
2. The battery pack is not charged.
3. The battery pack is over or under the
appropriate temperature range.
4. There is moisture on the leads of the
battery pack.
5. The battery pack is damaged.
6. There is another electrical problem
with the tool.
1. The battery pack charge capacity is
too low.
2. The air vents are blocked.
1. The attachment is not installed
correctly.
2. There is an issue with your attachment.
1. The battery pack is over or under the
appropriate temperature range.
PRELIMINARY
1. Remove and then replace the battery
2. Remove the battery pack from the tool
3. Move the battery pack to a place
4. Allow the battery pack to dry or wipe it
5. Replace the battery pack.
6. Contact an Authorized Service Dealer.
1. Remove the battery pack from the tool
2. Clean the air vents.
1. Refer to your attachment Operator's
2. Refer to your attachment Operator's
1. Move the battery pack to a place
11
Corrective Action
into the tool, making sure that it is fully
installed and latched.
and charge it.
where it is dry and the temperature is
between 5°C (41°F) and 40°C (104°F).
dry.
and fully charge the battery pack.
Manual.
Manual.
where it is dry and the temperature is
between 5°C (41°F) and 40°C (104°F).