Electrical Connections For Automatic Detergent And Rinse-Aid Dispensers; Hbefore First Use; Manual Activation; Setting The Dispensers - Electrolux EPPWA060 Installation And Operating Manual

Pot washer
Table of Contents

Advertisement

G.2.1
Electrical connections for automatic detergent
and rinse-aid dispensers
Terminals are available on the power supply terminal board for
the electrical connection of external dispensers working at 220
– 240 V. Max. power 30 VA.
• Connect the detergent dispenser between terminals 7 and 9.
These connection points are live for a set time during filling
of the tank and at the start of the wash cycle (see paragraph
H.2 Setting the dispensers).
H
BEFORE FIRST USE
H.1

Manual activation

Whenever the detergent containers are replaced, it may be
necessary to activate the dispensers manually in order to fill
the hoses and eliminate any air. Simultaneously press the
buttons, as shown in the figures below. If necessary, repeat
this operation several times.
Detergent dispenser
H.2

Setting the dispensers

All operations should be carried out with the appliance
switched on, the hood open and no cycle selected.
Press, together, the "On/Off" and "Wash cycle 1" buttons for 5
seconds to access the programming mode and the display
shows the parameter USr.
Press the button "L" (refer to F.1 Control panel description)
twice to access the detergent and rinse aid adjustment
parameters.
Rinse-aid dispenser
• Connect the rinse-aid dispenser between terminals 8 and 9.
These connection points are live during filling of the tank
and at the end of the rinse cycle for a set time (see H.2
Setting the dispensers paragraph).
Adjust the following parameters:
Parameter description
Initial amount of detergent
Initial amount of rinse-aid
Amount of detergent during
the cycle
Amount of rinse-aid during
the cycle
1.
The values given in the table refer to the factory-settings.
• Press the "Wash cycle 1" and "Wash cycle 2" buttons
respectively to decrease/increase the value.
• Press the button "L" to store the set value and return to
parameter selection (see point 1).
• Press the "Wash cycle 2" buttons to go to the next the
parameter to modify.
• Press the "Wash cycle 3" button to exit the programming
mode.
1
Display
Value
dIn
240
rIn
18
dEt
16
rAi
7
17

Advertisement

Table of Contents
loading

Table of Contents