Table of Contents
Advertisement
• Remove the wooden spacers "A" on the machine base
unscrewing the four "M8" screws.
3
2
1
• Carefully remove the protective film from the outer panels
without tearing it, to avoid leaving traces of glue.
• Adjust the equipment by turning the special adjustable feet
and making sure it is perfectly level, both length wise and
crosswise.
E.6
Extraction hood
Make sure to install an extractor hood to remove the steam
produced by the machine.
The hood air flow must be calculated taking into account the
type of installation and the work environment where it is
installed.
In any case, an air flow rate of between 1000 m
m
3
/h is recommended.
A
A
M8
3
2
1
3
2
1
3
/h and 1500
E.7
Disposal of packing
The packing must be disposed of in compliance with the
current regulations in the country where the appliance is used.
All the packing materials are environmentally friendly.
They can be safely kept, recycled or burned in an appropriate
waste incineration plant. Recyclable plastic parts are marked
as follows:
Polyethylene
• Outer wrapping
• Instructions bag
Polypropylene
• Straps
Polystyrene foam
• Corner protectors
The parts in wood and cardboard can be disposed of,
respecting the current regulations in the country where the
machine is used.
E.8
Plumbing connections
• Connect the appliance water supply pipe "WI" (see the
Installation diagram) to the mains, fitting a cut-off tap [X], the
filter provided [Y] and a pressure gauge [Z] between the
appliance and the mains (see figure below).
Z
Y
X
• Check that the dynamic water supply pressure, measured
between the appliance and the main, is between 50 and 700
kPa [0.5 - 7 bar] (test while dishwasher tank or boiler is filling
with water).
NOTE!
If the pressure is too high, fit a suitable pressure
reducer on the inlet pipe.
• On the model with free-fall drainage:
connect the waste outlet pipe (detail "D" in the Installation
diagram) to the main drain pipe, fitting a trap, or place the
outlet pipe over an "S" trap set into the floor.
• On the model with drain pump:
position the outlet pipe at a maximum height of 800 mm
from the floor.
CAUTION
Always use a new set of joints if you
remove and reinstall the water inlet pipe to
the appliance.
3
2
1
13
Advertisement
Table of Contents
