B4 Detergent/Rinse-Aid Dispensers And Settings - Electrolux ZHTAROW User Manual

CALL THE SERVICE CENTRE
C1..C8
CALL THE SERVICE CENTRE
E1..E8
- The appliance continues to operate, but appropri-
ate checks by a technician are recommended.
B4 DETERGENT/RINSE-AID DISPENSERS AND
SETTINGS
If the appliance is connected to a water softener or
osmotic device, contact the detergent supplier for a
specific product.
ATTENTION
This machine must be operated with an automatic
detergent feeder and, if applicable, an automatic
chemical sanitizer feeder, including a visual means
to verify that detergents and sanitizers are delive-
red or a visual or audible alarm to signal if deter-
gents and sanitizers are not available for delivery
to the respective washing and sanitizing systems.
Please see instructions for electrical and plumbing
connections located in this manual and in the fee-
der equipment manual.
Connections for automatic detergent dispenser
(Figure 13)
Q
O
Figure 13
There are two holes (plugged) "O" (Ø 5 mm) for intro-
ducing the detergent. These holes may be easily iden-
tified from outside by looking for the countersunk
marks on the external panel.
Inside the tank there is a hole "P" (Ø 10 mm) closed
with a plug, which may be used for mounting a liquid
detergent injector.
Only "OHTAROW / OHTAROW60" versions have a
solid detergent injector "Q" (Figure 13) on the back
side of the appliance.
O
P
Connections for automatic rinse-aid dispenser
(Figure 14)
R
R
Figure 14
Connect rinse-aid hose "R" (Figure 14) to automatic
rinse-aid dispenser.
Electrical connections for automatic detergent and
rinse-aid dispensers.
Terminals are available on the power supply terminal
board for the electrical connection of external dispens-
ers working at 220...240 V. Max. power 30 VA.
Figure 15
• Connect the detergent dispenser between termi-
nals 7 and 9. These connection points are live for a
set time during filling of the tank and at the start of
the wash cycle (see paragraph "Setting the dis-
pensers").
Figure 16
• Connect the rinse-aid dispenser between termi-
nals 8 and 9. These connection points are live dur-
ing filling of the tank and at the end of the rinse
cycle for a set time (see "setting the dispensers"
paragraph).
9