Download Print this page

B4 Detergent/Rinse-Aid Dispensers And Settings - Electrolux ZUCI Manual

Hide thumbs

Advertisement

Table of Contents
B1
INEFFICIENT DRAINAGE
-
Check if the overflow has been removed.
-
Check for obstruction on the waste outlet pipe and
the overflow aperture.
B2
TANK WATER LEVEL TOO HIGH
-
Check for obstruction on the waste outlet pipe and
the overflow aperture.
C1..C8
CALL THE SERVICE CENTRE
E1..E8
CALL THE SERVICE CENTRE
-
The appliance continues to operate, but appro-
priate checks by a technician are recommended.
CALL THE SERVICE CENTRE
F21..F22
B4
DETERGENT/RINSE-AID DISPENSERS AND
SETTINGS
If the appliance is connected to a water softener or
osmotic device, contact the detergent supplier for a
specific product.
Peristaltic dispensers (rinse-aid and detergent) require
periodic maintenance. The internal hose of the rinse-
aid dispenser should undergo periodic maintenance
(at least once or twice a year).
1. Dishwasher with incorporated detergent dis-
penser pump (Figure 13).
Pump "R" dispenses about 0.9 g/s of detergent. When
the appliance is filled with water for the first time in the
day, it dispenses about 44 g of detergent in 45 sec.,
thereby providing a concentration of 2 g/l. Pump "R"
dispenses about 6 g in 6 sec. at each cycle.
Dispenser operating time may be changed, following
the instructions given in the next paragraph.
Insert the hose provided in the kit into the detergent
container.
2. Dishwashers
with
rinse-aid dispenser pump (Figure 13).
Pump "S" dispenses about 0.1 g/s of rinse-aid. It
dispenses 0.3 g in 3 sec. at each rinse.
Dispenser operating time may be changed, following
the instructions given in the next paragraph.
Insert the hose provided in the kit into the rinse-aid
container (in the versions without incorporated rinse-
aid dispenser only).
3. Dishwashers
with
diaphragm dispenser pump (Figure 13).
Pump "T" is installed in appliances with pressure boi-
ler.
Dispensed amounts may be changed according to the
instructions given in the paragraph below.
Insert the supplied hose into the rinse-aid container (in
the versions without incorporated rinse-aid dispenser
only).
incorporated
peristaltic
incorporated
rinse-aid
Connections for automatic detergent dispenser
(Figure 13)
P
R
S
Figure 13
There is a ready-made impression "N" to be perforated
(Ø 8 mm) for positioning the detergent concentration
measuring sensor.
Inside the tank there is a hole "P" (Ø 10 mm) closed
with a plug, which may be used for mounting a liquid
detergent injector.
The Ecotemp versions have a hole "N" (Ø 22 mm) clo-
sed with a plug. The sensor and liquid detergent
injector should be installed without prejudicing the
watertightness of the appliance.
Electrical connections for automatic detergent and
rinse-aid dispensers
Terminals are available on the power supply terminal
board for the electrical connection of external dispen-
sers working at 220...240 V. Max. power 30 VA.
Figure 14
Connect the detergent dispenser between termi-
nals 7 and 9. These connection points are live for a
set time during filling of the tank and at the start of
N
T
D
L1
L2
L3
9

Advertisement

Table of Contents
loading

  Also See for Electrolux ZUCI

This manual is also suitable for:

AuciEucaimlEucaimlgEucimEucaiusphEuci